Panasonic FP2-PP2T Technical Manual page 70

4. The [Interpolation group settings] dialog is shown. Set the grouping that the interpolation
operation is executed for the selected axes in the above setting.
Independent
Interpolation group
Synchronous group
Synchronous
operation 1
Synchronous
operation 2
Synchronous mode
Master axis
Slave axis
Difference value
Difference behavior
Initialize
OK
Cancel
7-8
The area of the axes to be used as independent axes without performing
the interpolation operation.
The area of the groupings of the axes to perform the interpolation
operation. Up to 4 groups can be specified.
The area to be used for setting the synchronous operation.
It is used to set the synchronous operation group 1. Check the box to
perform the synchronous operation.
It is used to set the synchronous operation group 2. Check the box to
perform the synchronous operation.
It is used to set the synchronous operation mode. Select either Mode A or
B.
It is used to set the master axis for performing the synchronous operation.
It is used to set the slave axis for performing the synchronous operation.
The slave axis can be specified for an independent axis only.
It is used to set the maximum value of the difference between the master
axis and the slave axis during the synchronous operation.
It is used to set the operation to be performed when the difference
between the master axis and slave axis exceeded the difference value.
It is used to initialize the setting for the interpolation group and the
synchronous operation.
Determine the allocation of the interpolation groups.
Back to the previous setting for the axes to use.