Table of Contents
Advertisement
Appendix
D. Connecting the Third-party Exposure Switch(Optional)
This section explains on how to connect the third-party exposure switch with the equipment from
VATECH.
How-to:
1. Cut the exposure switch cable provided with the equipment.
2. According to the following schematic diagram, rewire the cables.
3. Double-check the wiring before use.
See the following note: important
Exposure Switch
LED LAMP
Exposure Switch
Customer Connection
Note: tape the end of each unused wire to prevent the wires from causing an inadvertent short circuit
152
System Board
Pax-i3D Smart(PHT-30LFO) Installation Manual
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PaX-i3D Smart and is the answer not in the manual?