Vatech PaX-i3D Smart Installation Manual page 11

Pax-i3D Smart(PHT-30LFO) Installation Manual
Installation Site
1. The PC monitor, emergency cut off switch and X-Ray exposure switch
should be installed in the vicinity of the operator so that he or she can
manage them simultaneously in an emergency.
2. Proper shielding of the room is essential: Since these requirements vary
depending on the country, it is the installer's responsibilities to verify that
all applicable radiation safety requirements are met.
3. This equipment should not be installed in the immediate vicinity of other
devices.
4. Do not install the equipment in an area that is exposed to strong
electromagnetic fields.
5. Do not install this system in an area where there is the risk of an explosion.
6. The electrical installation of this system shall comply with all local code
requirements for electro-medical systems: IEC 60364-7-710:2002.
7. It is strongly recommended that a UPS be installed at the same time as the
equipment.
8. The equipment, PC, and all peripheral devices must be well grounded
Warnings Regarding X-Ray Radiation
1. Failure to install this equipment in an approved location may be dangerous
to the patient and operator.
2. Stationary radiation shielding must be installed to protect the operator from
radiation.
3. The X-Ray system may cause injury to the patient if improperly used. Obey
all federal and municipal standards regarding radiation safety.
4. When exposing the patient to the X-Ray, the operator must be behind a
protective wall or take other protective actions. The operator should remain
at least 2 m (7 feet) away from the X-Ray when pressing the exposure
switch and observe the patient and capture-progression.
5. Operators must provide protective clothing to the patient before X-Ray
capturing. Pregnant women must consult with a doctor prior to being
exposed to an X-Ray.
Notice to the Installers
11