Connecting The Third-Party Exposure Switch(Optional) - Vatech EzRay Air Wall VEX-S300W Installation Manual

Connecting the Third-party Exposure Switch(Optional)

This section explains how to connect the third-party exposure switch with the
equipment from VATECH.
How-to:
1. Cut the exposure switch cable provided with the equipment.
2. According to the following schematic diagram, rewire the cables.
3. Double-check the wiring before use.
Note: tape the end of each unused wire to prevent the wires from causing an inadvertent
short circuit
EzRay Air Wall (Model: VEX-S300W) Installation Manual
Appendix
65