8 Installing Software
3. Enter the command PVER] to verify the current mode. Note that the equipment is now in packing mode.
4. Enter the command PKEN_0000] to exit the packing mode. Now note that the equipment is out of
the packing mode.
Note: to re-enter the packing mode, use the command: PKEN_0001].
5. Click Exit button and terminate the control panel.
6. Exit the imaging program (main GUI): important!
7. Reset the equipment to take the changes into effect
120
Pax-i3D Smart(PHT-30LFO) Installation Manual
Need help?
Do you have a question about the PaX-i3D Smart and is the answer not in the manual?