Table of Contents
Advertisement
Step 35: Attach TNR Brace Assembly
A: Use (8965) TNR Upright as a guide to judge the proper bolt location, remove the bottom pan bolt and nut .
The bolt will no longer be needed, but keep the lock nut. (fig. 35.1 and 35.2)
B: Attach the top of the TNR3 Post Mount to TNR2 Slide Clamp Ring using 1 (PB2) 1/4 x 1-1/4" Pan Bolt (with
the previously removed lock nut and 1 flat washer). (fig. 35.2)
C: Insert TNR3 Post Mount on (8965) TNR Upright, pre-drill with a 1/8" drill bit then attach with 2 (S6) #12 x 1"
Pan Screws. (fig. 35.2)
D: Attach (8963) TNR Ground Brace flush to the bottom of (2770) End Panel Left with 2 (S11) #8 x 2" Wood
Screws and 1 (S4) #8 x 3" Wood Screw. (fig. 35.1 and 35.3)
Fig. 35.1
2770
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB2 (1/4 x 1-1/4" Pan Bolt
with previously removed
lock nut)
Remove H9 (1/4 x 1-1/4"
Hex Bolt) first then install
TNR Brace Assemlby
8965
with Wood Screws as
noted in Fig. 35.3
TNR Brace
Assembly
Hardware
1 x
1/4 x 1-1/4" Pan Bolt
PB2
1 - (1/4" flat washer, 1/4" lock nut - previously removed)
2 x
S6
#12 x 1" Pan Screw
1 x
#8 x 3" Wood Screw
S4
2 x
#8 x 2" Wood Screw
S11
Fig. 35.2
TNR2 Slide
Clamp Ring
PB2
Fig. 35.3
S11
88
Lock
Nut
1/4" Flat
Washer
8965
S6
2618
S4
Other Parts
1 x TNR3 Post Mount
TNR3 Post
Mount
8963
Advertisement
Table of Contents
