KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 26

Step 3: Swing Wall Prep
Part 3
It is important to assemble the frame on a flat, smooth surface.
E: Attach (2630) SW Top to (2757) LT Post Assembly and (2758) RT Post Assembly with 2 (WB1) 5/16 x 1"
Wafer Bolts (with flat washer) connecting to previously installed t-nuts. (fig. 3.5 and 3.6)
F: Attach (2768) Panel Floor to (2757) LT Post Assembly and (2758) RT Post Assembly with 2 (H9) 1/4 x 1-1/4"
Hex Bolts (with lock washer and flat washer) connecting to previously installed t-nuts. (fig. 3.5)
G: Place 1 (2778) SW Ground MOD to each side of (2769) Panel BT Frame, notice the hole locations and attach
with 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock washer and flat washer) per board connecting to previously installed
t-nuts. (fig. 3.5 and 3.7)
H: Place 1 (2607) Diagonal under (2778) SW Ground MOD on the right hand side so the top sits against (2758)
RT Post Assembly and loosely attach with 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock washer, flat washer and t-nut).
(fig. 3.5 and 3.7)
Fig. 3.5
2630
Fig. 3.6
WB1
2778
Wood Parts
4 x SW Ground MOD 5/4 x 4 x 14-1/4"
2778
2 x Diagonal 1-1/4 x 3 x 22"
2607
WB1
x 2
2768
FW2
Fig. 3.7
2769
4 x
WB1
4 x
H9
6 x
H10
H9
x 2
2758
2757
Note which bolt holes are used
Hardware
5/16 x 1" Wafer Bolt (5/16" flat washer)
1/4 x 1-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer)
1/4 x 2-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer and 2 1/4" t-nut)
26
2607
LW1
2769
2778
H10
x 3
FW1
TN1
2778
2778