KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 35

Step 6: Attach Tunnel Inserts
Part 1
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
A: The Fort Assembly on the left will be referred to
as Unit A and the Fort Assembly on the right will be
referred to as Unit B . The inner Side Walls will now be
Tunnel Side Walls. (fig. 6.1 and 6.2)
B: Place Unit A and Unit B side by side so the
opening next to the Swing Wall in Unit A Tunnel Side
Wall lines up with the opening next to the Front Wall in
Unit B Tunnel Side Wall. (fig. 6.2)
C: The distance between Unit A and Unit B must be
33-1/2". Measure at the ground, floor and top to make
sure distances are the same. (fig. 6.1)
Fig. 6.2
FINAL LOCATION MUST BE LEVEL GROUND
Unit A
Fig. 6.1
Top View
Unit A
Swing Wall
Tunnel Side
Wall
Tunnel Side
Wall
Front Wall
35
33-1/2"
Unit B
Unit B