Table of Contents
Advertisement
DO NOT USE
DO NOT USE
USE IMAGE
Step 32: Attach Elbow Assembly to Elbow Assembly
USE IMAGE
Part 2
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the
round recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose
until further step.
C: Attach 1 TNR2 Slide Clamp Ring to the bottom of the joined Assemblies using 3 (PB1) 1/4 x 3/4" Pan Bolts
(with lock nut), making sure to match the arrows up with the end of the clamp ring (where a seam will be) as
shown in fig. 32.3 and 32.4.
D: Connect the 2 TNR2 Slide Clamp Rings together in 2 spots using 1 (PB1) 1/4 x 3/4" Pan Bolt (with lock
nut) per hole. Make sure seams and arrows line up and then tighten all bolts. (fig. 32.3 and 32.5).
Fig. 32.4
Bottom Slide Bolt Holes
Elbow
Assembly
PB1
Hardware
5 x
PB1
Elbow
Assembly
Lock
Nut
Fig. 32.5
1/4 x 3/4" Pan Bolt
(1/4" lock nut)
85
Fig. 32.3
Make sure arrows
are aligned
Lock
PB1
Nut
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
Other Parts
1 x TNR2 Slide Clamp Ring
Advertisement
Table of Contents
