KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 61

Step 20: Attach Rock Wall Assembly to Fort
Part 2
C: Drive 1 Rebar Ground Stake 13" into the ground against 1 (2776) Rock Rail per assembly then attach with 1
(S7) #12 x 2" Pan Screw per ground stake . Be careful not to hit the washer while hammering stake into the ground
as this could cause the washer to break off. (fig. 20.5 and 20.6)
D: After driving stake into the ground, check for sharp edges caused by the impact of the hammer . Smooth any
sharp edges from impact area and touch up with outdoor paint .
driven 13" into ground. Digging or driving stakes can be dangerous if you do not
check first for under-ground wiring, cables or gas lines.
Fig. 20.5
2776
Warning!
To prevent tipping and avoid potential injury, stakes must be
Unit B
2776
Unit A
Hardware
2 x #12 x 2" Pan Screw
S7
61
Fig. 20.6
Other Parts
2 x Rebar Ground Stake
2776
S7
Rebar
Ground
Stake