Table of Contents
Advertisement
Step 11: Swing Beam Assembly
A: Attach 6 Swing Hangers to the (2614) Engineered Beam using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with 2 flat
washers and 1 lock nut) per Swing Hanger as shown in fig. 11.1.
B: Flush to the Fort End of (2614) Engineered Beam attach 2 L-Beam Brackets with 2 (G21) 5/16 x 3-3/4" Hex
Bolts (with 2 flat washers and 1 lock nut). (fig. 11.1 and 11.2)
C: Install 1 (WB7) 5/16 x 3" Wafer Bolt (with flat washer and t-nut) in the middle bolt hole in (2614) Engineered
Beam as shown in fig. 11.3. IT IS IMPORTANT THAT THIS BOLT IS ATTACHED. IT WILL MINIMIZE
CHECKING OF WOOD.
D: Attach KidKraft Plaque to centre of (2614) Engineered Beam (over top of t-nut) using 4 (S18) #6 x 1" Wood
Screws. (fig. 11.4)
Fig. 11.1
Fort End
Fig. 11.2
Fort End
LN2
L-Beam
Bracket
Flush
L-Beam
Bracket
G21
Wood Parts
1 x
Engineered Beam 4 x 6 x 88"
2614
Swing Hanger x 6
FW2
2614
FW2
FW2
12 x
G7
5/16 x 5-1/2" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
2 x
5/16 x 3-3/4" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
G21
1 x
5/16 x 3" Wafer Bolt (5/16" flat washer & 5/16" t-nut)
WB7
4 x
#6 x 1" Wood Screw
S18
Fig. 11.3
TN2
Hardware
45
2614
LN2
G7
S18
2614
KidKraft Plaque
WB7
6 x Swing Hangers
2 x L-Beam Bracket
1 x KidKraft Plaque
Swing End
FW2
Fig. 11.4
x 4
Other Parts
Advertisement
Table of Contents
