Table of Contents
Advertisement
Step 3: Swing Wall Prep
Part 2
It is important to assemble the frame on a flat, smooth surface.
C: Turn the (2757) LT Post Assembly and (2758) RT Post Assembly over and place 2 (2756) Siding Assemblies
on top so one sits flush with the top of the middle groove and the second fits flush with the top of the bottom
groove. (fig. 3.2 and 3.3)
D: Place (2630) SW Top in the top grooves, (2768) Panel Floor in the middle grooves and (2769) Panel BT
Frame in the bottom grooves so they sit flush to the outside edges of (2757) LT Post Assembly and (2758) RT
Post Assembly . Make sure the assembly is square then attach with 4 (S30) #8 x 1-1/16" Wood Screws per
board. (fig. 3.4)
Fig. 3.2
Top
2757
Top
Fig. 3.3
Fig. 3.4
2630
Wood Parts
4 x
Siding Assembly 1-1/4 x 19-15/16 x 39-3/16"
2756
2 x
SW Top 1-1/4 x 5-1/2 x 42"
2630
2 x
Panel Floor 1-1/4 x 3 x 42"
2768
2 x
Panel BT Frame 1-1/4 x 3 x 42"
2769
2756
Flush
Notice Orientation of both
(2756) Siding Assemblies.
Flush
24 x
2758
S30
x 4
S30
2768
2757
Hardware
#8 x 1-1/16" Wood Screw
S30
25
2756
Bottom
x 4
2758
Flush
S30
x 4
2769
Advertisement
Table of Contents
