KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 29

Step 4: Fort Assembly
Part 2
B: Place Front Wall from Step 2 between the Side Walls noticing the wall orientation . The tops and bottoms of
the walls should be flush. Make sure the walls are square then using the pilot holes as a guide pre-drill with a
3/16" drill bit and fasten the right Side Wall to the Front Wall and Front Wall to the left Side Wall with 4 (WL5) 1/4
x 2-1/2" Wafer Lags per side. (fig. 4.4)
Fig. 4.4
WL5
Notice right Side Wall
overlaps Front Wall
Right
Side Wall
Front Wall
16 x
Left
Side Wall
Hardware
1/4 x 2-1/2" Wafer Lag
WL5
29
Swing Wall
Notice Front Wall
overlaps left Side
Wall