KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 78

Step 29: Slide Section Assemblies
Part 1
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the
round recess and the lock nuts go through the side with the hexagonal recess. (fig. 29.3)
A: Fit 2 TNR2 Slide Elbows together and attach with 8 (PB1) 1/4 x 3/4" Pan Bolts (with lock nut) as shown in
fig. 29.1. It is very important to attach bolts as indicated.
B: Repeat Step A 3 more times to create 4 Elbow Sections in total .
C: Attach TNR3 Extend Flange RT and TNR3 Extend Flange LT together using 9 (PB1) 1/4 x 3/4" Pan Bolts
(with lock nut) as shown in fig. 29.2. This creates the Flange Assembly.
Fig. 29.1
Lock
Nut
PB1
Lock
Nut
Use a 7/16" open end
wrench for nuts
Fig. 29.2
PB1
TNR2
Slide
Elbow
Fig. 29.3
PB1
Hardware
41 x
PB1
Lock
Nut
Flange
Assembly
TNR3
PB1
Extend
x 4
Flange RT
1/4 x 3/4" Pan Bolt
(1/4" lock nut)
78
TNR3
Lock
Extend
Nut
Flange LT
PB1
Lock
Nut
Other Parts
1 x TNR3 Extend Flange RT
1 x TNR3 Extend Flange LT
8 x TNR2 Slide Elbow