KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 107

Step 45: Attach Roof Assembly to Fort
Part 2
For Unit A
D: Place (9450) Roof Tie so that the angled end is flush against (2761) Roof Sleeper C and the other end is
flat against (2775) Panel Cross Support, centered between the Hex Bolts. Attach using 4 (S11) #8 x 2" Wood
Screws, making sure that the top 2 screws are installed on an angle as shown in fig. 45.3.
E: Repeat Step D to install a (9450) Roof Tie to (2761) Roof Sleeper C and (2769) Panel BT Frame on the
opposite side of the roof .
For Unit B
F: Place (9450) Roof Tie so that the angled end is flush against (2761) Roof Sleeper C and the other end is flat
against (2630) SW Top, centered between the Hex Bolts . Attach using 4 (S11) #8 x 2" Wood Screws, making
sure that the top 2 screws are installed on an angle as shown in fig. 45.3.
G: Repeat Step F to install a (9450) Roof Tie to (2761) Roof Sleeper C and (2769) Panel BT Frame on the
opposite side of the roof .
2761
Fig. 45.3
2775 9450
Wood Parts
4 x Roof Tie 1-1/4 x 2 x 7-9/16" (31.8 x 50.8 x 192mm)
9450
Unit A
S11
x 4 per
tie
Hardware
16 x #8 x 2" Wood Screw
S11
107
Unit B
2761
9450
S11
2630
x 4 per
tie