Fig. 4.1 - KidKraft KINGSBRIDGE Installation And Operating Instructions Manual

Step 4: Fort Assembly
Part 1
It is important to assemble the Fort Assembly on a flat, smooth surface.
A: Place Swing Wall from Step 3 between 2 Side Walls from Step 1, noticing the wall orientations . The tops and
bottoms of the walls should be flush. Make sure the walls are square then using the pilot holes as a guide pre-
drill with a 3/16" drill bit and fasten the left Side Wall to the Swing Wall and Swing Wall to the right Side Wall with
4 (WL5) 1/4 x 2-1/2" Wafer Lags per side. (fig. 4.1, 4.2 and 4.3)
Left

Fig. 4.1

Top View
Side Wall
Notice left Side
Wall overlaps
Swing Wall
WL5
Flush
Fig. 4.2
Flush
Swing Wall
Notice counter sunk
holes on the outside
Swing Wall
Side Wall
16 x
WL5
Right
Side Wall
Notice Swing Wall
overlaps right Side Wall
Flush
WL5
Left
Flush
Hardware
1/4 x 2-1/2" Wafer Lag
28
Fig. 4.3
Notice grooves
face inwards
Side Wall
WL5
x 4 per
side
Right