KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 38

Step 7: Tunnel Floor Assembly
Part 2
D: Flush to the ends and sides of both (9088) Tunnel Side Joist place 1 (9087) Floor Board followed by 7 (9092)
Floor Boards. Make sure the last board is flush to the ends of each (9088) Tunnel Side Joist then attach all floor
boards with 4 (S20) #8 x 1-3/8" Wood Screws. (fig. 7.3)
E: Measure 1-1/4" in from both ends of each (9088) Tunnel Side Joist then attach 1 Swing Bracket to each
end with 1 (WB2) 5/16 x 1-3/8" Wafer Bolt (with flat washer, connects to already installed t-nuts) per bracket.
Brackets must be flush to the bottom of the boards. (fig. 7.4)
Fig. 7.3
Flush
9088
9087
9088
Fig. 7.4
9088
9088
Wood Parts
1 x Floor Board 1 x 4 x 16-7/8"
9087
7 x Floor Board 1 x 5 x 16-7/8"
9092
FW2
Flush WB2
x 4
1-1/4"
9092
x 4
Hardware
32 x #8 x 1-3/8" Wood Screw
S20
4 x 5/16 x 1-3/8" Wafer Bolt (5/16" flat washer)
WB2
38
S20
x 4 per
board
Swing
Bracket
Flush
1-1/4"
Other Parts
4 x Swing Bracket
Flush
x 4