KidKraft KINGSBRIDGE Installation And Operating Instructions Manual page 80

Step 30: Attach Flange Assembly to Fort
Part 1
A: With a helper place the Flange Assembly flush to the top opening in the Front Wall on Unit A as shown in fig.
30 .1, then pre-drill 1/8" pilot holes in (8935) Lower SL Insert for the 4 bottom mounting locations (approximate
spots where circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep. (fig. 30.2)
B: Attach Flange Assembly to (8935) Lower SL Insert using 4 (S7) #12 x 2" Pan Screws (with #12 Screw Bezel)
in the pre-drilled holes. (fig. 30.2) Make sure the flat surfaces of the Flange Assembly are flush to (2769) Panel
BT Frame, (2770) End Post Left and (2602) Upper Jamb as shown in fig. 30.3.
C: Attach the Flange Assembly flush to top of (2769) Panel BT Frame using 4 (S6) #12 x 1" Pan Screws (with
#12 Screw Bezel) and to (2602) Upper Jamb and (2770) End Post Left using 5 (S6) #12 x 1" Pan Screws per
side. (fig. 30.2)
Fig. 30.2
Flange
Inside View
Assembly
2602
Front Wall
8935
Unit A
Top
S6
w/ #12 Screw
Bezel
S7
w/ #12 Screw
Bezel
14 x
4 x
8 x
Fig. 30.1
Outside View
2770
2769
Flange
Assembly
Side
S6
(5 per side)
Hardware
#12 x 1" Pan Screw
S6
#12 x 2" Pan Screw
S7
#12 Screw Bezel
80
Top
8935
Top of End Wall
Fig. 30.3
opening
2769
2602
Bottom of
slide flush with
(8935) Lower
SL Insert