Load The Last Setup; Configure Your Multilogpro; Input Mode - Fourier MultiLogPRO User Manual

1.2.8.

Load the Last Setup

When you turn MultiLogPRO on, once the self testing has been completed, it will
display:
_ _ _ I N I T I A L I Z A T I O N _ _ _
I n i t . D i s p l a y
I n i t . A D C
I n i t . R A M
B a t t . 9 9 %
E N T E R – l o a d s e t u p
Press the Enter button
1.2.9.

Configure Your MultiLogPRO

Use the System configuration menu to select the Input Mode, to clear the
MultiLogPRO's memory, to change the screen contrast, or to calibrate the DO
sensor.
In the MAIN MENU screen, select the System configuration icon
configuration screen. The default configuration is:
→
Use the Forward
then press the Enter button
Escape button
changes you made. Press Enter button in the last item (Contrast) if you want to go
back to the first item (Input Mode).

1. Input Mode

Select between Auto ID – automatic sensor identification and 8 inputs – manual
sensor selection (See also page 7).
The new configuration will be the default mode until the next time you change it.
18 Chapter 1 MultiLogPRO
to load the last setup.
Input Mode: Auto ID
Clear memory ( > )
DO2 calibration ( > )
Contrast ( < ) ( > )
Comm ( PC )
and Backward
to move to the next item. You can press the
to leave the configuration menu at any time, saving the new
to display the
arrows to select the mode and
2