Fourier MultiLogPRO User Manual page 17

2. Plug in the Sensors
Start with the first input on the right. If MultiLogPRO is in Auto ID mode (the default
mode) it will display the setup menu and will identify the sensors you've plugged in.
→
Note: Sensors must be added successively, starting with input-1. If a single sensor is
used it must be connected to I/O-1. If two sensors are used in an experiment, they
must be connected to I/O-1 and I/O-2.
The arrow indicates that MultiLogPRO is ready to accept a new sampling rate.
If the MultiLogPRO is in 8 input mode, you have to select the sensors manually (see
page 13).
3. Select Rate
Use the Forward
rate, and then press the Enter button
→
MultiLogPRO automatically switches to the next step in the setup process and the
arrow moves to the samples row.
8 Chapter 1 MultiLogPRO
In–1: Microphone
In–2: Light
In–3:
In–4:
RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
and Backward
.
In–1: Microphone
In–2: Light
In–3:
In–4:
RATE = Every sec
SAMPLES = 500
DISPLAY = numeric
arrow buttons to select the desired