Getting Started; Set Up A Recording Session; Prepare Multilogpro; Enable Video Recording - Fourier MultiLogPRO User Manual

2.3. Getting Started

2.3.1.

Set up a Recording Session

1. Prepare MultiLogPRO

1. Connect MultiLogPRO to the PC (see page 4)
2. Turn on MultiLogPRO
Note: MultiLogPRO must be in PC communication mode (see page 18).
3. Plug in any external sensors
4. Open the MultiLab software

2. Enable Video Recording

Note: Do not plug in the PC camera before you have installed the camera driver (see
page 26 for installation instructions).
To display the video window and enable online video and video recording:
1. Connect the camera to the PC
Note: When you plug in the supplied Web camera for the first time Windows will
automatically detect the new device and open the Found New Hardware Wizard.
Follow the on-screen instructions. When asked, select the Install software
automatically option (there is no need to insert the installation CD).
Windows will automatically detect and install the necessary software
2. Click Video on the menu bar, then click Enable video
MultiLab will remember the video settings until the next time you change them.
Note: if more than one video source is connected to your computer MultiLab will use
the default source. To select another source click Video on the menu bar and click
Select video device, then select the desired source from the drop list that opens and
click OK.
3. Click Video
4. Point the camera to the experiment setup.
on the main toolbar to display the video window.
Chapter 2 MultiLab Software 31