Select Sensors Manually - Fourier MultiLogPRO User Manual

1.2.7.

Select Sensors Manually

You must be in 8 input mode to be able to select the sensors manually (see page 7).
1. In the Main Menu screen, use the arrow buttons to select the setup
menu icon
2. Press the Enter button
→
3. Use the Forward
the sensor in input 1 and then press the Enter button
arrow indicator will move to the second input.
4. Repeat this procedure with all the sensors you plugged in.
5. After the fourth sensor has been selected, the screen will list the
next 4 sensors:
→
You can press the Enter button in the last input if you want to go back to the first
input.
6. When you've finished selecting the sensors press the Escape
button
you must complete the setup, as detailed in section 1.2.3.
Note: When you turn the MultiLogPRO off it will save the setup for the next session.
.
In–1: Empty
In–2: Empty
In–3: Empty
In–4: Empty
RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
and Backward
In–5: Empty
In–6: Empty
In–7: Empty
In–8: Empty
RATE = 10/s
SAMPLES = 500
DISPLAY = numeric
. The arrow indicator will point to the Rate command and
to enter the setup menu:
arrows to select
Chapter 1 MultiLogPRO
. The
17