Load The Last Setup; Internal Clock And Calendar; Clear The Memory - Fourier TriLink User Manual

If the TriLink is in 8 Sensors mode you have to select the sensors manually from
MultiLab.
3. Start recording
Press the Run/Stop
TriLink will use the stored setup parameters to collect data (see page 14)
The LCD screen will display:
At rates of up to 10 samples per second TriLink displays the recorded data values.
You can stop recording any time by pressing the Run/Stop
time. Otherwise logging will stop after the selected number of samples where taken.
The LCD screen will display the number of the experiment in TriLink's memory:
1.2.4.

Load the Last Setup

When you turn TriLink on, once the self testing and selection of the input modes has
been completed, it will automatically load the last setup you've used.
1.2.5.

Internal Clock and Calendar

The internal clock is set the first time you use the Setup command from the MultiLab
software to program the TriLink, and is automatically updated to the PC's time and
date each time you connect your TriLink to a PC.
The internal clock and calendar is kept updated even when the TriLink is turned off,
but it will be erased if the 2.4V battery is dead. It will be updated the next time TriLink
will be connected to a computer or a Palm.
1.2.6.

Clear the Memory

TriLink automatically checks the available memory before it begins the recording. If
there is not enough memory you will see this message on the display:
Press the Run/Stop button to clear the memory and begin recording.
16 Chapter 1 TriLink
button to start recording.
Logging
_ _ _ LOGGER – RUN _ _ _
Log 01 ended
_ _ _ LOGGER-RUN _ _ _
Clear = (Run)
button a second