Figure 52: Moving To The Global Configuration Mode; Figure 53: Confirmation Prompt For The No Stack Enable Command; Figure 54: Returning To The Privileged Exec Mode - Allied Telesis AT-x510-28GPX Installation Manual

Chapter 5: Powering On the Switch
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z
awplus(config)#
Warning; This will disable the stacking hardware on member-1.
Are you sure you want to continue? (y/n):
92
If the Operational Status is "Standalone Unit," as shown in Figure

51 on page 91, the VCStack feature is active on the unit. You must
disable it by performing the steps in the rest of this procedure
before you can use the SFP+ stacking slots with regular SFP or
SFP+ transceivers. The reason the status says "standalone" is
because the switch considers itself a stack of one switch.
4. Move to the Global Configuration mode by entering the ENABLE and
CONFIGURE TERMINAL commands, as shown in Figure 52.
Figure 52. Moving to the Global Configuration Mode
5. To. disable the VCStack feature on the switch, enter the NO STACK
ENABLE command, which has this format:
id
no stack enable
The ID parameter is the ID number of the switch, displayed on the ID
LED. Replace the parameter with whatever number is on the ID LED.
For example, if the ID number of the switch is 1, the default value,
enter the command as follows:
awplus(config)# no stack 1 enable
This confirmation prompt in Figure 53 is displayed.
Figure 53. Confirmation Prompt for the NO STACK ENABLE Command
6. Type Y to disable VCStack on the switch or N to cancel the procedure.
7. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 54.
awplus(config)# exit
awplus#
Figure 54. Returning to the Privileged Exec Mode
8. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 55 on page
93.