Table of Contents
Advertisement
Section 2 - Familiarization
Base Control
Platform Capacity
Selector Switch
Start/Function Enable/
Emergency Power Switch
Off/Base/Platform Key
2.4 Function Tests
Function tests are designed to discover any malfunctions
before aerial platform is put into service. The operator
must understand and follow step-by-step instructions
to test all aerial platform functions.
IMPORTANT
Never use a malfunctioning aerial
platform. If malfunctions are discovered,
aerial platform must be tagged and taken
out of service. Repairs to aerial platform
may only be made by qualified/competent
repair personnel.
NOTE
To perform this function test, ensure there
is sufficient space to fully raise and extend
boom.
After repairs are completed, operator must perform a
pre-operation inspection and a series of function tests
again before putting aerial platform into service.
Prior to performing function tests, be sure to read and
understand
Section 3.7
- Start Operation.
NOTE
All-function motion alarm should sound
while operating any boom and drive
function.
SJ 82T & SJ 86T
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Console
Switch
contained in this operating manual and on the aerial platform.
2.4-1 Test Main Power Disconnect Switch
1.
In engine compartment, turn main power
disconnect switch to "
Result: Aerial platform functions should not
operate.
2.
In engine compartment, turn main power
disconnect switch to " " on position.
NOTE
Close all cowlings before proceeding to
next item.
2.4-2 Base Control Console
1.
On platform control console, pull out "
emergency stop button.
2.
On base control console, pull out "
stop button.
3.
Turn off/base/platform key switch to "
position.
4.
Start engine by selecting "
start/function enable/emergency power switch.
Function Tests
Emergency Stop
" off position.
" emergency
" base
" start position from
Page 31
"
Advertisement
Table of Contents
