Skyjack SJ82T Operating Manual page 17

Section 2 - Familiarization
2.2-10 Base Control Console (Continued)
11. Status Indicator Pilot Lights - These lights
indicate operational status and errors in any
function in the controls/engine.
A B C
A. Water In Fuel Light - This light indicates water
separator is full. Open drain to release water.
Engine damage could occur if ignored for
excessive length of time.
B. Engine Oil Pressure - This light indicates low
engine oil pressure.
C. Engine Coolant Temperature/Level - This
light indicates overheating of engine coolant
and low level of engine coolant.
D. Engine - This light indicates failure in engine
control system.
E. Fuel - This light indicates low fuel level.
F. Glow Plug (Diesel) - This light illuminates
until glow plugs have completed their timed
cycle. When the lamp goes out, the engine is
ready to be started.
SJ 82T & SJ 86T
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
1
17
16
15
14
13
12 11
Figure 2-6. Base Control Console
D E F
contained in this operating manual and on the aerial platform.
2 3
4
5
6
7
8
9
18 10
12. Off/Base/Platform Key Switch - This three-way
selector switch allows operator to "
power to aerial platform or to activate either "
base or " " platform control console.
13. Start/Function Enable/Emergency Power
Switch - This momentary switch, when held in
" " start position, starts engine. When held in
" " function enable position, allows base control
functions to operate. Engine speed increases
when selected. With engine off, and when held
in " " emergency power unit position,
allows base control functions to operate using
emergency power unit.
14. Capacity Zone Border Light - Indicates aerial
platform is at limits of travel for high capacity zone.
Lower " " and "
available.
15. High Capacity Zone Indicator Light - Indicates
aerial platform is in "high" platform capacity zone.
Refer to Table 4.4.
Control Functions
" turn off
"
" extend functions are not
Page 17