Table of Contents
Advertisement
Start Operation
3.7-8
To Operate Using Emergency Power
Switch at Base Control Console
This is a momentary-type switch. This switch allows
all functions except the drive function to operate in the
event of engine malfunction. Refer to
emergency lowering procedure.
3.7-9
To Activate Platform Control Console
1.
In engine compartment, turn main power
disconnect switch to " " on position.
2.
On base control console, turn off/base/platform
key switch to "
3.
On base control console, pull out "
stop button.
Ensure that you maintain three points of
contact to mount/dismount the platform.
DO NOT operate any control on operator's
control console without proper fall
protection secured to the designated
location in the platform. Failure to avoid
this hazard could result in death or
serious injury.
4.
Enter platform and close gate/drop bar.
5.
Attach body harness lanyards of each occupant
to fall protection anchorage points. Rated for one
(1) person per anchorage.
6.
On platform control console, pull out "
emergency stop button.
Page 60
Section 2.6
"platform position.
" emergency
WARNING
WARNING
7.
Select "
switch until engine starts.
Select desired platform capacity using
for the
platform capacity selector switch. High
platform capacity is automatically selected.
DO NOT over crank the starter. If engine
fails to start after multiple attempts,
contact qualified/competent repair
Engine will not start if you are pressing
8.
Select desired engine RPM using throttle switch:
"
" high or "
DO NOT drive or steer the aerial platform when
•
the platform position does not allow you a clear
view of the base.
•
Your area of operation should be cordoned
from other personnel or equipment.
"
Section 3 - Operation
" start position from engine start/on/off
NOTE
WARNING
personnel.
NOTE
down on the footswitch.
" low.
WARNING
SJ 82T & SJ 86T
Advertisement
Table of Contents
