Skyjack SJ82T Operating Manual page 33

Section 2 - Familiarization
Base Control
Platform Capacity
Selector Switch
Start/Function Enable/
Emergency Power Switch
Off/Base/Platform Key
• Test Emergency Power
1. On base control console, push in "
emergency stop button to turn engine off.
2. On platform control console, push in "
emergency stop button.
When operating on auxiliary power, do
not operate more than one function
at a time to avoid overloading 12-Volt
auxiliary pump motor.
To conserve battery power, test each
function through a partial cycle.
Ensure that there are no personnel or
obstructions in test area and there is
sufficient room for boom to swing.
3. On base control console, pull out "
emergency stop button.
4. Select "
position from start/function enable/
emergency power switch and activate
each boom function.
SJ 82T & SJ 86T
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Console
Switch
CAUTION
NOTE
WARNING
" emergency power
contained in this operating manual and on the aerial platform.
Result: All selected functions should
operate.
"
• Test Off/Base/Platform Switch
1. Ensure both "
"
buttons are pulled out.
2. Start engine.
3. On base control console, turn off/base/
platform key switch to "
Result: Engine should shut down and
aerial platform functions should not
operate.
4. On base control console, turn off/base/
platform key switch to "
position.
"
Function Tests
Emergency Stop
" emergency stop
" off position.
" platform
Page 33