Table of Contents
Advertisement
Section 3 - Operation
3.7-10
To Drive Forward or Reverse Using
Platform Control Console
When you are in the platform and
positioned over an axle, the direction
you are facing will be forward.
1.
Depress and hold footswitch.
2.
Push and hold drive/steer controller in this
direction "
" to drive forward or "
backward.
3.
Release controller handle to stop.
The drive orientation can change when
the turret is swung 90 degrees off center
of the normal driving position (roughly
when boom is swung past the rear tire).
Drive re-orientation will not occur while
driving and rotating until the joystick
is released for 6 seconds or when the
footswitch is released.
When driving on a slope:
•
Torque Switch MUST be in high
torque mode.
•
DO NOT exceed the rated
gradeability listed in
•
Ensure fuel level is above half to
avoid a possible stall condition.
3.7-11
To Steer Using Platform Control Console
1.
Depress and hold footswitch.
2.
Press rocker on top of drive/steer controller in this
direction "
" to steer left or "
Driving and steering may be active at the
same time.
SJ 82T & SJ 86T
CAUTION
" to drive
CAUTION
CAUTION
Table
4.2a.
" to steer right.
NOTE
3.7-12
To Move Jib Up and Down Using
Platform Control Console (If Equipped)
1.
Depress and hold footswitch.
2.
On jib up/down switch, select "
up or "
" to move jib down. Vary speed with
"
" boom speed adjuster dial. Release switch
to stop.
3.7-13
To Extend or Retract Fly Boom Using
Platform Control Console
Select desired platform capacity using
platform capacity selector switch. High
platform capacity is automatically selected.
1.
Depress and hold footswitch.
2.
On fly boom extend/retract switch, select "
to extend fly boom or "
Vary speed with "
Release switch to stop.
3.7-14
To Level Platform Using Platform Control
Console
1.
Depress and hold footswitch.
2.
On platform leveling override switch, select
"
" to tilt platform up or "
platform down. Release switch to stop.
3.7-15
To Rotate Platform Using Platform
Control Console
1.
Depress and hold footswitch.
2.
On platform rotation switch, select "
platform left or "
speed with "
Release switch to stop.
Start Operation
" to move jib
NOTE
" to retract fly boom.
" boom speed adjuster dial.
" to rotate
" to rotate platform right. Vary
" boom speed adjuster dial.
Page 61
"
" to tilt
Advertisement
Table of Contents
