Skyjack SJ82T Operating Manual page 32

Function Tests
Base Control
Platform Capacity
Selector Switch
Start/Function Enable/
Emergency Power Switch
Off/Base/Platform Key
• Test Emergency Stop
1. Push in " " emergency stop button.
Result: Engine should shut down and
aerial platform functions should not
operate.
2. Pull out " " emergency stop button and
restart engine.
• Test Start/Function Enable/Emergency
Power Switch and All Boom Functions
Ensure that there are no personnel or
obstructions in test area and there is
sufficient room for boom to swing.
1. Ensure " " emergency stop button is
pulled out.
2. Start engine.
3. Do not hold "
emergency power switch in function
enable position. Attempt to activate each
boom and platform switch.
Result: All boom and platform functions
should not operate.
Page 32
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Console
Switch
WARNING
" start/function enable/
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
Emergency Stop
4. Hold " " start/function enable/
emergency power switch in function
enable position and activate each boom
and platform function.
Result: Engine speed increases from idle
to intermediate. All boom and platform
functions should operate as selected.
• Test Platform Self-leveling
1. Lower boom to stowed position.
2. Adjust platform to a level position using
platform leveling switch, which controls
" " tilting up or "
of platform.
3. Fully raise " " main boom.
Result: Platform should remain level at all
times and lifting speed should slow down
before boom reaches full height.
4. Fully lower " " main boom.
Result: Platform should remain level at all
times.
" tilting down
SJ 82T & SJ 86T