Skyjack SJ82T Operating Manual page 40

Function Tests
Engine Start/On/
Off Switch
• Test Steering
1. Pull out " " emergency stop button.
2. Start engine by selecting "
position from engine start/on/off switch.
3. Depress and hold footswitch.
4. Press rocker switch on top of drive/steer
controller to "
Result: Steer wheels should turn left and
right.
5. Return wheels to parallel position before
proceeding.
• Test Driving Function
1. Ensure path of intended motion is clear.
2. Ensure boom is in stowed position and fly
boom fully retracted.
3. Depress and hold footswitch.
Page 40
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Emergency Stop
Horn
Platform Capacity
Selector Switch
" start
" left and " " right.
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
Emergency Power
Switch
Platform Leveling
Override Switch
4. Slowly move drive/steer controller in
" " forward or "
until aerial platform begins to move, and
then return handle to center position.
Result: Aerial platform should move in
forward or reverse direction, and then
come to a stop.
• Test Driving Speed
1. Depress and hold footswitch.
2. Raise " " main boom approximately
14 ft. (4 m) and then slowly move drive/
steer controller to full drive position.
Result: The maximum achievable drive
speed should be significantly less than
stowed drive speed.
3. Lower boom to stowed position.
4. Extend " " fly boom approximately
12 in. (30 cm) and then slowly move drive/
steer controller to full drive position.
Result: The maximum achievable drive
speed should be significantly less than
stowed drive speed.
Drive/Steer
Controller
" reverse direction
SJ 82T & SJ 86T