Component Identification (Optional Equipment/Attachments) - Skyjack SJ82T Operating Manual

Component Identification (Optional Equipment/Attachments)

3.5 Component Identification (Optional
Equipment/Attachments)
The following descriptions are for identification,
explanation and locating purposes only.
3.5-1 AC Outlet on Platform (If Equipped)
This outlet is a source of AC power on the platform. The
outlet is located on the right side of platform control
console and the plug is located beside hydraulic tank
in control compartment.
Figure 3-1. AC Outlet and Electrical Plug
3.5-2 Cold Weather Start (If Equipped)
The battery warmer/hydraulic oil heater cord is located
in the engine compartment near the engine.
Figure 3-2. Battery Warmer/Hydraulic Oil Heater Cord
1. Battery Warmer/Hydraulic Oil Heater Cord - This
cord is plugged into the AC outlet at least 4 hours
before starting engine when temperature gets
below -10°C (+14°F).
Page 54
3.5-3 Flashing Amber Light (If Equipped)
The flashing amber light is located on top of the turret
of the aerial platform.
1
1. Flashing Amber Light - This light flashes
when boom function is activated. This works in
conjunction with all motion alarm.
3.5-4 Work Light (If Equipped)
The work light assembly is mounted on top of the
railings of the platform.
1
Ensure base emergency stop button is
pulled out and platform control console
has been activated using off/base/platform
1. Work Light - This light turns on when the work
light switch is activated.
Work lights are not intended to replace
the ambient lighting required to navigate
Section 3 - Operation
Figure 3-3. Flashing Amber Light
Figure 3-4. Work Light
NOTE
key switch.
WARNING
and operate this aerial platform.
1
SJ 82T & SJ 86T