Skyjack SJ82T Operating Manual page 34

Function Tests
Platform Control
Console
Fall Protection
Anchorage
Ensure that you maintain three points
of contact to mount/dismount platform.
5. Enter platform and close gate/drop bar.
6. On platform control console, select
" " on position from engine start/on/off
switch.
7. Select " " start position from engine
start/on/off switch until engine starts.
8. Dismount from platform.
9. On base control console, attempt to
activate each boom and platform switch
while holding start/function enable/
emergency power switch in function
enable position.
Result: All boom and platform functions
should not operate while holding start/
function enable/emergency power switch
in function enable position.
10. Push in "
turn engine off.
11. Pull out " " emergency stop button.
Page 34
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
WARNING
" emergency stop button to
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
Emergency Stop
Footswitch
Drive/Steer
Controller
Fall Protection
Anchorage
SJ 82T & SJ 86T