Table of Contents
Advertisement
Function Tests
Platform Control
Console
Fall Protection
Anchorage
2.4-3 Platform Control Console
WARNING
Ensure that you maintain three points of
contact to mount/dismount platform.
1.
On base control console, turn off/base/platform
key switch to "
" platform position.
2.
Enter platform and close gate/drop bar.
WARNING
DO NOT operate any control on platform
control console without proper fall
protection secured to designated location
in platform. Failure to avoid this hazard
could result in death or serious injury!
WARNING
Ensure that there are no personnel or
obstructions in test area and that there is
sufficient room for boom to swing.
•
Test Footswitch
1. Ensure "
" emergency stop button is
pulled out.
Page 38
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
Emergency Stop
Footswitch
2. Ensure engine start/on/off switch is in
"
" on position.
3. Do not start engine.
4. Select generator on/off switch to off
position (if equipped).
5. Depress and hold footswitch and attempt
to start engine by selecting "
position from engine start/on/off switch.
Result: Engine should not start.
6. Without depressing footswitch, try to start
engine.
Result: Engine should start.
7. W ith engine running and without
depressing footswitch, test each boom
and platform function.
Result: Aerial platform functions should
not operate.
NOTE
A
15-second
anti-tiedown
deactivates footswitch when operator
depresses it for 15 seconds without
activating any function.
Drive/Steer
Controller
Fall Protection
Anchorage
" start
feature
SJ 82T & SJ 86T
Advertisement
Table of Contents
