Ethernet Interface Configuration - Cabletron Systems 2H28-08R User Manual

Chapter 5: Local Management
5.11

ETHERNET INTERFACE CONFIGURATION

Access the Ethernet Interface Configuration screen from the Device
Configuration Menu screen by using the arrow keys to highlight the
ETHERNET INTERFACE CONFIGURATION menu item and
pressing ENTER. The Ethernet Interface Configuration screen displays.
Event Message Line
Device Type: 2H28-08R
Port
Port
Num
Type
1 FE-100FX
2 FE-100FX
3 FE-100FX
4 FE-100FX
5 FE-100FX
6 FE-100FX
7 FE-100FX
8 FE-100FX
SAVE
Figure 5-17 Ethernet Interface Configuration Screen for the 2H28-08R
The following section briefly explains each field of the Ethernet Interface
Configuration screen:
Port Num (Read-only)
Identifies the port number.
Port Type (Read-only)
Displays the name of the interface in ports 1 through 8. "Unknown" will
be displayed for port 7 or 8 if a Fast Ethernet Module is not installed in
those ports.
5-40
2H28-08R LOCAL MANAGEMENT
Ethernet Interface Configuration
Link Current
Status Oper. Mode
No Link 100Base-FX
No Link 100Base-FXFD
No Link 100Base-FXFD
No Link 100Base-FXFD
Link 100Base-FXFD
No Link 100Base-FXFD
100Base-FX
Link
100Base-FXFD
Link
2H28-08R SmartSwitch 2208 User's Guide
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
Desired
Oper. Mode Advertised Ability
[100Base-FX] N/A
[100Base-FXFD] N/A
[100Base-FXFD] N/A
[100Base-FXFD] N/A
[100Base-FXFD] N/A
[100Base-FXFD] N/A
[Auto-Neg]
[10Base-TFD]
[100Base-FXFD] N/A
EXIT
XX.XX.XX
[Enabled]
RETURN
2159-23