Image File Download Using Tftp - Cabletron Systems 2H28-08R User Manual

Chapter 5: Local Management
BootP. Section 5.14.1 describes how to download using TFTP.
Section 5.14.2 describes how to download using Runtime.
Reboot After Download (Modifiable only when user chooses RUNTIME)
This field notifies the user that the 2H28-08R will reboot after completing
the download. If a Runtime Download is performed, this field toggles
between YES and NO. If YES is selected, the device reboots after the
download is completed. If NO is selected, the device continues using the
existing firmware image and stores the new firmware image in FLASH
memory. When the device is reset or during the next power-up, the device
boots from FLASH memory using the new image.
TFTP Gateway IP Addr (Modifiable)
This field shows the IP address of the TFTP gateway server defined on the
General Configuration screen in Section 5.7.4.
Last Image Server IP (Read-only)
This field shows the IP address of the server used for the previous FLASH
Download.
Last Image File Name (Read-only)
This field shows the complete path and file name of the last image
downloaded to FLASH.
If TFTP or RUNTIME is selected as the download method
(Figure 5-20), the following two additional fields display:
Download Server IP (Modifiable)
The IP address of the TFTP server to be used for the FLASH download is
entered in this field.
Download File Name (Modifiable)
The complete TFTP server path and file name of the new image is entered
in this field.

5.14.1 Image File Download Using TFTP

To download a firmware image to the 2H28-08R using TFTP, proceed as
follows:
1. Use the arrow keys to highlight the Download Method field.
5-50 2H28-08R SmartSwitch 2208 User's Guide