Cabletron Systems 2H28-08R User Manual page 141

2. If the 2H28-08R is rack mounted, remove it from the rack and remove
the rackmount brackets (refer to
and Mode Switch Bank
3. Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See
4. Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
Front Panel
Note: If the device was rack mounted, the four screws fastening the cover to
the front panel are removed and installed along with the rackmount brackets.
2H28-08R SmartSwitch 2208 User's Guide
Settings).
Figure C-1.)
Figure C-1 Removing the Chassis Cover
Removing the Chassis Cover
Chapter 3, Optional Installations
Chassis Cover
Cover Screws (7)
Chassis
2251-30
C-3