Image File Download Using Bootp - Cabletron Systems 2H28-08R User Manual

Chapter 5: Local Management
6. Set the IP address of the TFTP gateway server (this defaults to the
same IP address as that set in the TFTP Gateway IP Addr field on the
General Configuration screen). To set the IP address, refer to
Section 5.7.4.
7. Use the arrow keys to highlight the Download Server IP field.
8. Enter the IP address of the TFTP server using the DDN format.
For example: 134.141.79.121
9. Use the arrow keys to highlight the Download File Name field.
10. Enter the complete pathway and file name of the image stored on the
download server.
For example: /tftpboot/2H28.fls
11. Use the arrow keys to highlight EXECUTE at the bottom of the screen
and press ENTER. The message "TFTP DOWNLOAD. WILL
COMMIT TO FLASH. REBOOT IN PROGRESS..." displays in the
event message line at the top of the screen and the new image is
downloaded into FLASH memory.

5.14.3 Image File Download Using BootP

To download a firmware image to the 2H28-08R using BootP, proceed as
follows:
1. Use the arrow keys to highlight the Download Method field.
2. Use the SPACE bar to select BOOTP.
3. Use the arrow keys to highlight the TFTP Gateway IP Addr field.
4. Set the IP address of the TFTP gateway server (this defaults to the
same IP address set in the TFTP Gateway IP Addr field in the General
Configuration screen). To set the IP address, refer to
5. Use the arrow keys to highlight EXECUTE at the bottom of the screen
and press ENTER. The message "BOOTP DOWNLOAD. WILL
COMMIT TO FLASH. REBOOT IN PROGRESS..." displays in the
5-52 2H28-08R SmartSwitch 2208 User's Guide
Section 5.7.4.