Cabletron Systems 2H28-08R User Manual page 145

When installing Fast Ethernet Interface Modules in both port
slots 7 and 8, remove the coverplates from both slot openings.
TIP
In the following instructions, the optional module is shown
being installed in port slot 8.
1. Remove the coverplate from the port slot where the Fast Ethernet
Interface Module will be installed. Refer to
follows:
a. Remove the two screws fastening the coverplate to the standoffs.
Save the screws.
b. Lift and remove the coverplate from the top of the front standoffs.
Coverplate
2. Remove the screw from the rear standoff. Save the screw.
When installing an FE-100FX or FE-100F3 module into the
NOTE
2H28-08R, remove the rubber plug on the module before
proceeding.
2H28-08R SmartSwitch 2208 User's Guide
Installing Optional Fast Ethernet Interface Modules
7
8
Figure C-4 Coverplate Removal
Figure C-4 and proceed as
Rear
Standoff
Front
Standoffs
2251-38
C-7