Setting The Ip Address - Cabletron Systems 2H28-08R User Manual

Chapter 5: Local Management
Clear NVRAM (Toggle)
Allows the user to reset NVRAM to the factory default settings. All
user-entered parameters, such as IP address and Community Names, are
then replaced with 2H28-08R default configuration settings. For details,
refer to Section
5.7.1

Setting the IP Address

To set the IP address, perform the following steps:
1. Use the arrow keys to highlight the IP Address field.
2. Enter the IP address into this field using Dotted Decimal Notation
(DDN) format.
For example: 134.141.79.120
3. Press ENTER. If the IP Address is a valid format, the cursor returns to
the beginning of the IP Address field. If the entry is not valid, the
screen displays the message "INVALID IP ADDRESS OR FORMAT
ENTERED". Local Management does not alter the current value and
refreshes the IP Address field with the previous value.
4. Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown in
5-20
5.7.11.
2H28-08R SmartSwitch 2208 User's Guide
Figure 5-10 displays.