Cabletron Systems 2H28-08R User Manual page 65

Event Message Line
Device Type: 2H28-08R
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Operational Mode: [802.1D SWITCHING]
Com 1: [ENABLED]
Clear NVRAM: [NO]
SAVE
The following briefly explains each General Configuration screen field:
MAC Address (Read-Only)
Displays the base physical address of the 2H28-08R.
IP Address (Modifiable)
Displays and allows the user to set the IP address for the 2H28-08R. To
set the IP address, refer to
through Runtime IP Address Discovery as previously described in
Section 1.3.5.
Subnet Mask (Modifiable)
Displays the subnet mask for the 2H28-08R. A subnet mask "masks out"
the network bits of the IP address by setting the bits in the mask to 1 when
the network treats the corresponding bits in the IP address as part of the
network or subnetwork address, or to 0 if the corresponding bit identifies
the host. Once an IP address has been entered, the device will
automatically generate and display a default subnet mask based on the
entered IP address. For details about changing the subnet mask from its
default value, refer to
2H28-08R SmartSwitch 2208 User's Guide
2H28-08R LOCAL MANAGEMENT
General Configuration
00-00-ID-00-00-00
0.0.0.0
0.0.0.0
NONE DEFINED
0.0.0.0
Application:
Figure 5-9 General Configuration Screen
Section
Section 5.7.2.
General Configuration Screen
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Device Uptime: XX D XX H XX M
[LM]
EXIT
5.7.1. The IP address can also be set
XX.XX.XX
11/11/1997
14:23:00
03 sec.
15 min.
RETURN
2286-15
5-17