Port Redirect Function Screen - Cabletron Systems 2H28-08R User Manual

event message line at the top of the screen and the new image is
downloaded into FLASH memory.
5.15

PORT REDIRECT FUNCTION SCREEN

The Port Redirect Function screen may not be available
NOTE
depending on the operational mode that has been set for the
device. Refer to the Release Notes to see what operational
modes support the Port Redirect function. Refer to
Section 5.7.9
mode of the device.
The Port Redirect Function screen,
each port as source or destination ports. A port can be set to have one or
more destination ports. For example, port 1 can be set as a source port
with three destinations, ports 2, 3, and 4. Traffic from port 1 is then
automatically redirected to ports 2, 3, and 4. Port 1 can also serve as a
destination port for other ports.
The Port Redirect function is extremely useful for troubleshooting
purposes, as it allows traffic to be sent to a particular port(s) where, with
the use of an analyzer or RMON probe, all current traffic from the source
port(s) can be examined.
Although all traffic from the source port (including errored
NOTE
frames, if desired) is sent to the destination port, normal
switching is still performed for all frames on the source port.
2H28-08R SmartSwitch 2208 User's Guide
for instructions on configuring the operational
Figure
Port Redirect Function Screen
5-21, allows the user to set
5-53