Chapter 3 Installation; Required Tools; Unpacking The 2H28-08R - Cabletron Systems 2H28-08R User Manual

Only qualified personnel should install the 2H28-08R.
This chapter provides the instructions to install the 2H28-08R. Follow the
order of the sections listed below to correctly install the 2H28-08R.
•

Required Tools

•

Unpacking the 2H28-08R

• Installing Optional Equipment
• Installing the 2H28-08R (on a shelf, tabletop, or into a standard rack)
(Section 3.4)
• Connecting to the Network
• Completing the Installation
3.1 REQUIRED TOOLS
A Phillips screwdriver is required to install the 2H28-08R in a rack, and to
install any optional Fast Ethernet Interface Modules.
3.2 UNPACKING THE 2H28-08R
To unpack the 2H28-08R and verify the contents of the shipment, proceed
as follows:
1. Open the carton and remove the packing material protecting the
2H28-08R.
2. Verify the contents of the carton as listed in
2H28-08R SmartSwitch 2208 User's Guide
CHAPTER 3
INSTALLATION
(Section 3.1)
(Section
(Section
(Section
(Section
3.2)
3.3)
3.5)
3.6)
Table 3-1.
3-1