Cabletron Systems 2H28-08R User Manual page 128

Chapter 5: Local Management
soft_reset
Syntax:
Description:
The Network Tools connection to the device will be terminated
upon execution of this command.
TIP
Options:
Example:
telnet:
Syntax:
Description:
Options:
5-80
soft_reset
This command restarts the software image,
which restores the user configuration settings
from NVRAM. The user will be queried to
confirm the reset command to ensure against
unwanted resets.
Not Applicable
-> soft-reset
RESET: Are you *SURE*? ->Y
telnet [IP address] <Port #>
The telnet command allows the user to
communicate with another host (that supports
Telnet connections) using the Telnet protocol.
The user must specify the remote host using its
IP address. The [IP address] field is mandatory.
If no Port number is specified, telnet will
attempt to contact the host at the default port.
Not Applicable
2H28-08R SmartSwitch 2208 User's Guide
22511-76