MEcHANIcAL INSTALLATION
5.7 Installation of the coolant connection
5.7.1 General information
•
•
•
•
•
5.7.2 coolant connection
The connection for the coolant is located in the base of the cabinet system, it is designed
as a 1 1/4 inch internal thread.
Figure 21:
52
The connection to the cooling system can occur as closed or open cooling circuit.
The connection to a closed cooling circuit is recommended since the risk of contam-
ination of the cooling liquid is extremely low.
Preferably, a monitoring of the pH-value of the cooling liquid should also be installed.
For required potential equalization, a corresponding conductor cross-section must
be taken into consideration, in order to keep electrochemical processes as low as
possible.
For more information, refer to „Annex - Cooling System".
Coolant connection