Safety - When Operating - Fayat Group Dynapac CA25 Instruction Manual

Fig. Positioning the rollers when
driving near the start of a slope.
Fig. Operação em declives
02-17-2021

Safety - When operating

Operating on slopes
When driving near the start of slopes, at least 2/3 of the
width of the machine should be on land with full load
capacity.
Inclination
This angle was measured on a flat and hard base with the
machine stopped.
The steering angle is 0 with vibrations off and all reservoirs
full.
When driving the machine on a stable floor, the application
of vibration, the speed of the machine on the ground and
the lifting of the center of gravity can cause the machine to
overturn, even on a lower slope indicated in this manual.
ₒ
4812325897EN
Keep in mind that the machine's center of gravity
moves outwards when steering. For example, the
center of gravity moves to the right when you steer
to the left.
To exit the cab in an emergency, release the
hammer on the rear right post and break the
rear window.
When operating on slopes or unstable bases,
the use of ROPS (Roll Over Protection
Structure) or a ROPS approved cabin is
always recommended. Always use a seat
belt.
Avoid driving across slopes.
On slopes, drive straight up and down.
Special instructions
8