Safety - When Operating - Fayat Group CP1200 Instruction Manual

Máx. 20°
or 36%
Fig. – Slopes angle
08/01/2023

Safety - When operating

Avoid people entering at the danger area, that is,
at a distance of at least 23 ft (7 m) in all the
directions from the machine operating. The
operator can allow one person to be at the danger
area, but in this case, care must be taken and the
machine can only be operated when this person
is in a visible place or with clear indication of
where he/she is.
Avoid driving across a slope. Drive straight up and
down sloping ground.
Operating on slopes
The machine must never be operated from the
outside of the cab. The operator shall be seated
when operating.
Slopes
This angle was measured on a flat, hard surface and with the
machine in a stationary position.
The steering angle is zero, the tires pressure is normal and all
the tanks are full.
Always remember that loosen ground, the steering of the
machine, different tire pressures, the operation speed and the
gravity center raising may cause the machine to turn, even on
slopes smaller than the ones stated here.
If you need to leave the cab in emergency
situations, take off the hammer at the rear pillar on
the right and break the opening windows that are
also on the right.
It is recommended that ROPS (Roll Overprotective
Structure) is always used when driving on slopes
or unsafe ground.
Whenever possible, avoid driving across slopes.
On slopes, drive straight up and down.
The speed must always be slow when operating on
slopes.
Always operate the machine with the doors closed
and with the seat belt.
4812325556EN
Safety
5