Fayat Group Dynapac CA25 Instruction Manual page 76

Fig. Engine left side:
1. Drain plug;
Fig. Fuel filter
02-17-2021
Maintenance, 250 hours
Every 250/750/1250/1750 hours of operation (monthly)
Diesel engine - Oil and filter change
Take great care when draining warm fluid and oil. Wear
protective gloves and goggles.
The oil drain plug (1) can be accessed most easily under
1
the engine. Shut down the machine and drain the oil when
the engine is warm. Place a container with a minimum
capacity of 19 liters under the drain plug.
Replace the engine oil filter at the same time. Refer to the
engine manual.
Value of plug tightening torque: 24 N.m
Hand in the drained oil and filter to an environment-
friendly waste disposal station.
Diesel engine - Fuel filter and pre-filter
Replace
Remove the threaded fuel filter using the filter wrench.
Lubricate the O-ring with clean engine oil.
Do not pre-fill the engine fuel filter.
Install the filter in the filter head. Tighten the filter until the
gasket touches the surface of the filter head. Tighten the
fuel filter plus ¾ turn after contact.
Bleed the fuel system after installing the fuel filter.
Refer to the bleed procedure in the engine manual.
4812325897EN
Maintenance – 250 h
76