Fayat Group Dynapac CA25 Instruction Manual page 90

Fig. Drum, left side
1. Filler/drain plug
Fig. Cartridge, left side
1. Filler plug
2. Drain plug
3. Sight glass
Fig. Right side of the machine
1. Steering pump
2. Rear axle
3. Engine suspension
4. Wheel nuts
02-17-2021
Drum cartridge - Checking the oil level
Position the roller on a flat surface with the plug (1) and
drum number plate (2) are visible on the right side.
The oil level should now reach the sight glass (3).
If necessary, remove the plug (1) and fill to the middle of
the sight glass.
Clean the magnetic filler plug (1) of any metallic residue,
before refitting the plug.
Refer to the correct oil grade in the lubricant specification.
Do not overfill with oil - risk for overheating.
joints – Check
Bolted
Steering pump to Diesel engine (1), 55 N.m, lightly
lubricated.
Rear axle suspension (2), 330 N.m (243 ft/lbf), oiled.
Engine suspension (3). Check if all M12 bolts (20 pieces)
are tightened with 70 N.m and lightly greased.
Wheel nuts (4). Check if all nuts are tight, 630 N.mm, and
oiled.
(The above information is valid only for new or replaced
components).
4812325897EN
Maintenance – 1000 h
90