Fayat Group Dynapac CA25 Instruction Manual page 82

Fig. Air filter
1. Clips
2. Cover
3. Main (primary) filter
4. Backup (secondary) filter
5. Filter housing
6. Dust valve
Fig. Cab
1. Filters (2x)
2. Screws (3x)
Fig. Level control - differential
housing
1. Level plug (3x)
2. Filler plug.
02-17-2021
Air filter – Replace the primary air filter
Change the air cleaner's main filter when the
warning lamp on the display lights when the diesel
engine is operating at full speed
Release the clips (1), pull off the cover (2), and pull out
the main filter (3).
Do not remove the backup filter (4).
Clean the air filter if necessary, see section Air Filter -
Clean.
When replacing the main filter (3), insert a new filter and
refit the air cleaner in the reverse order.
Check the condition of the dust valve (6); replace if
necessary.
When refitting the cover, make sure that the dust valve is
positioned downwards.
Air conditioning (Optional) Fresh air filter –
Change/Clean
There is a fresh air filter (1), located at the front of the cab.
Remove the three screws (2) and remove the protective
cover.
Clean or replace them with new filters
It may be necessary to change the filters more often if the
machine is working in a dusty environment.
Rear axle differential - Check oil level
Never work under the roller when the engine is
running. Park on a level surface. Block the
wheels securely.
Wipe clean and remove the level plugs (1) and check that
the oil level reaches the lower edge of the plug holes. If
the level is low, remove the filler plug (2) and top up with
oil to the correct level. Use transmission oil, refer lubricant
specifications.
Clean and refit the plug.
4812325897EN
Maintenance – 500 h
82